LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2008 >> i-290 Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim And Upholstery >> Repair Instructions >> Front Seat Lumbar Support Replacement >> Removal Procedure

Removal Procedure

  1. Remove the seat from the vehicle. Refer to Split Bench Seat Replacement  or Front Seat Replacement - Bucket .
  2. Remove the seat back cover and pad. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement .
  3. Remove the seat back panel. Refer to Driver Seat and Passenger Seat Back Cushion Finish Panel Replacement .
  4. Disconnect the electrical connector from the lumbar motor.
    5. Fig 1: View Of Seat Back Frame Wire & Lumbar
    GM1333675Courtesy of GENERAL MOTORS CORP.
  5. Detach the seat back frame wire (1) from the top of the lumbar (2).
  6. Detach the seat back frame wire from the bottom of the lumbar.
    7. Fig 2: View Of Lumbar Assembly
    GM1333679Courtesy of GENERAL MOTORS CORP.
  7. Drill out and remove the 2 lumbar motor mounting rivets (3).
  8. Remove the lumbar assembly (1) from the seat.
scientia non olet · About LEMON Manuals