LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2008 >> i-290 Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim And Upholstery >> Repair Instructions >> Front Seat Lumbar Support Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Lumbar Assembly
    GM1333679Courtesy of GENERAL MOTORS CORP.
  1. Position the lumbar assembly (1) onto the seat.
  2. Install the lumbar motor to the seat frame with 2 new rivets (3).
    3. Fig 2: View Of Seat Back Frame Wire & Lumbar
    GM1333675Courtesy of GENERAL MOTORS CORP.
  3. Attach the top and bottom of the lumbar (2) onto the seat back frame wire (1).
  4. Connect the electrical connector to the lumbar motor.
  5. Install the seat back panel. Refer to Driver Seat and Passenger Seat Back Cushion Finish Panel Replacement .
  6. Install the seat back pad and cover. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement .
  7. Install the seat in the vehicle. Refer to Split Bench Seat Replacement  or Front Seat Replacement - Bucket .
scientia non olet · About LEMON Manuals