LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2008 >> i-290 Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim And Upholstery >> Repair Instructions >> Front Seat Cushion Frame Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Cupholder
    GM1333098Courtesy of GENERAL MOTORS CORP.
  1. Remove the seat from the vehicle. Refer to Front Seat Replacement - Bucket  or Split Bench Seat Replacement .
  2. Remove the cupholder from the seat by pulling it straight off the bracket.
  3. Remove the front seat cushion outer trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
    4. Fig 2: View Of Cupholder Bracket Bolts
    GM1333099Courtesy of GENERAL MOTORS CORP.
  4. Remove the 3 bolts (1) securing the cupholder bracket to the seat frame, if equipped.
    5. Fig 3: View Of J-Strips
    GM1333089Courtesy of GENERAL MOTORS CORP.
  5. Unclip the front, rear, and side J-strips (1, 2) on the underside of the seat.
  6. Remove the lumbar knob by pulling the knob straight away from the seat, if equipped.
  7. Remove the seat switch bezel, if equipped. Refer to Driver Seat and Passenger Seat Adjuster Switch Bezel Replacement .
  8. Remove the recliner handle. Refer to Driver Seat and Passenger Seat Recliner Handle Replacement .
    9. Fig 4: View Of Lumbar Adjustment Mechanism & Retaining Screws
    GM1333092Courtesy of GENERAL MOTORS CORP.
  9. Remove the screws (2) that retain the lumbar adjustment mechanism (1) to the seat adjuster.
  10. Remove the lumbar cable from the lumbar adjustment mechanism.
    11. Fig 5: View Of Seat Recliner Bolts
    GM1333093Courtesy of GENERAL MOTORS CORP.
  11. Remove the 2 bolts (1) securing the seat recliner to the seat adjuster.
  12. Remove the seat back assembly from the seat cushion assembly.
    13. Fig 6: View Of Seat Buckle Electrical Connector & Wiring Harness
    GM1333091Courtesy of GENERAL MOTORS CORP.
  13. Disconnect the seat belt buckle electrical connector (1).
  14. Remove any clips or straps securing the electrical harness to the bottom of the seat cushion frame.
    15. Fig 7: View Of Seat Belt Buckle Assembly
    GM1333095Courtesy of GENERAL MOTORS CORP.
  15. Remove the bolt (2) securing the seat belt buckle assembly (1) to the seat adjuster.
  16. Remove the seat cushion cover and foam.
  17. Remove the assist spring.
    18. Fig 8: View Of Wire Harness & Seat Cushion Frame Nuts
    GM1333096Courtesy of GENERAL MOTORS CORP.
  18. Disconnect the wire harness for the lumbar and seat heat switches and pull the harness (2) back through the hole in the seat cushion frame.
  19. Remove the 4 nuts (1) securing the seat cushion frame to the seat adjuster.
  20. Remove the seat cushion frame.
scientia non olet · About LEMON Manuals