LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2008 >> i-290 Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim And Upholstery >> Repair Instructions >> Front Seat Back Cushion Cover and Cushion Pad Replacement >> Installation Procedure

Installation Procedure

  1. Install the seat back heater element. Refer to Driver Seat and Passenger Seat Back Cushion Heater Replacement .
  2. Position the seat back pad to the seat back frame.
  3. Connect the electrical connector to the seat back heating element, if equipped.
  4. Partially install the seat back cover over the top of the seat.
  5. Install the head restraint guides to the seat frame. Ensure that the locking tabs are fully seated. The guide with the release tab goes on the right-hand side.
  6. Install the hog rings that retain the seat back pad to the reinforcement bar.
    7. Fig 1: View Of Seat Cover, Back Pad, & Velcro Retaining Strip
    GM1333660Courtesy of GENERAL MOTORS CORP.
  7. Pull the seat cover (1) over the seat back pad (3).
  8. Press the seat cover hook and loop retaining strips (2) together by firmly running your hand over the seat back cover (1).
    9. Fig 2: View Of Bottom Seat Back Cover J-Strip
    GM1333658Courtesy of GENERAL MOTORS CORP.
  9. Install the J-strip (1) across the bottom of the seat back cover.
  10. Install the head restraint. Refer to Front Seat Head Restraint Replacement .
  11. Install the seat cushion outer trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
  12. Install the seat back release handle. Refer to EZ Entry Seat Manual Release Knob Replacement .
  13. Install the seat in the vehicle. Refer to Split Bench Seat Replacement  or Front Seat Replacement - Bucket .
scientia non olet · About LEMON Manuals