LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2008 >> i-290 Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim And Upholstery >> Repair Instructions >> Driver Seat and Passenger Seat Back Cushion Finish Panel Replacement >> Installation Procedure

Installation Procedure

  1. Position the seat back panel on the seat-back frame.
  2. Install the seat back panel to the frame with a push-pin fastener (1) at the top of the panel.
    3. Fig 1: View Of Seat Back Panel & Fasteners
    GM1333666Courtesy of GENERAL MOTORS CORP.
  3. Install the 2 hog ring fasteners (3) to the bottom of the seat back panel (2).
  4. Install the front seat back cover and pad. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement .
  5. Install the seat in the vehicle. Refer to Split Bench Seat Replacement  or Front Seat Replacement - Bucket .
scientia non olet · About LEMON Manuals