LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2008 >> i-290 Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Seat Hardware, Seat Trim And Upholstery >> Repair Instructions >> Driver Seat and Passenger Seat Adjuster Switch Bezel Replacement >> Removal Procedure

Removal Procedure

  1. Remove the seat from the vehicle. Refer to Split Bench Seat Replacement  or Front Seat Replacement - Bucket .
  2. Remove the seat cushion outer trim panel from the seat assembly. Refer to Seat Cushion Outer Trim Panel Replacement .
    3. Fig 1: View Of Seat Switch Bezel
    GM1333643Courtesy of GENERAL MOTORS CORP.
  3. Remove the 3 screws (2) that retain the switch bezel (1) to the seat.
  4. Unhook the seat cushion cover J-strip from the top of the bezel.
  5. Remove the switch bezel from the seat by pulling out to release the retaining clips.
  6. Remove the seat switch from the switch bezel by releasing the retaining tabs. Refer to Power Seat Switch Replacement .
  7. Remove the lumbar switch from the switch bezel by releasing the retaining tabs. Refer to Lumbar Switch Replacement .
scientia non olet · About LEMON Manuals