Removal Procedure
- Remove the front seats. Refer to Split Bench Seat Replacement or Front Seat Replacement - Bucket .
- Remove the windshield garnish moldings. Refer to Windshield Pillar Garnish Molding Replacement .
- Disconnect the headliner harness (1) from the body harness (2).
- Remove the lower body rear corner trim panels. Refer to Body Side Rear Lower Trim Panel Replacement (Crew Cab) or Body Side Rear Lower Trim Panel Replacement (Extended Cab) or Body Side Rear Lower Trim Panel Replacement (Regular Cab) .
- Remove the upper body rear corner trim panels. Refer to Body Side Upper Trim Panel Replacement (Regular Cab, Extended Cab) or Body Side Upper Trim Panel Replacement (Crew Cab) .
- Remove the dome lamp. Refer to Dome Lamp Replacement .
- Remove the sunshades. Refer to Sunshade Replacement .
- Remove the passenger assist handle and the driver assist handle or assist handle blank. Refer to Assist Handle Replacement .
- Remove the coat hook. Refer to Coat Hook Replacement .
- Tilt the steering wheel to the full down position.
- If equipped with a manual transmission, place the transmission in 2nd gear and remove the shift knob handle.
- Remove the 2 push pins securing the headliner to the row bow.
- Remove the rear push pin from the headliner. Replace any damaged push pin spacers.
- Lower the forward edge of the headliner.
- Standing at the left front door, grasp the headliner at the dome lamp opening and at the headliner left edge.
- Slide the headliner forward and under the steering wheel.
- Rotate the forward edge of the headliner towards the right-hand door opening.
- Remove the headliner from the vehicle through the door opening.