LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - DTC P0218 To DTC P1810) >> DTC P0741 >> Test Description

Test Description

WARNING: This page is about a different variant/trim than selected.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  This step inspects for excessive TCC slip when the TCC is commanded ON.
  2. 3:  This step inspects for possible causes of no TCC apply.
DTC P0741

Step Action Values Yes No
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle
2 
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
    3. IMPORTANT: Before clearing the DTC, use the scan tool in order to record the Freeze Frame and Failure Records. Using the Clear Info function erases the Freeze Frame and Failure Records from the powertrain control module (PCM).
  3. Record the DTC Freeze Frame and Failure Records.
  4. Clear the DTC.
  5. Drive the vehicle in the D4 drive range in second, third or fourth gear under steady acceleration, with a TP angle at 20-99 percent.
While the scan tool TCC Enable is Yes, does the scan tool display a TCC Slip Speed greater than the specified range?		 130 RPM Go to Step 3  Go to Testing for Intermittent Conditions and Poor Connections
3  The TCC is hydraulically or mechanically stuck OFF. Inspect for the following conditions:
  • The TCC PWM valve for a damaged exhaust orifice
  • The converter apply valve being stuck in the OFF, release, position
  • A misaligned or damaged valve body gasket
  • A restricted apply valve passage
  • The torque converter clutch for being mechanically stuck OFF

Refer to Symptoms - Automatic Transmission NO TCC apply.
Was the condition found?		 - Go to Step 4  -
4 Perform the following procedure in order to verify the repair:
  1. Select DTC.
  2. Select Clear Info.
  3. Drive the vehicle in D3 under the following conditions:

    Hold the throttle at 20-99 percent and accelerate to 88 km/h (55 mph). Ensure that the TCC is commanded ON and the TCC Slip Speed is less than 50 RPM for 2 seconds.

  4. Select Specific DTC.
  5. Enter DTC P0741.

Has the test run and passed?		 - Go to Step 5  Go to Step 2 
5 With the scan tool, observe the stored information, capture info, and DTC Info.
Does the scan tool display any DTCs that you have not diagnosed?		 - Go to Diagnostic Trouble Code (DTC) List - Vehicle System OK
scientia non olet · About LEMON Manuals