LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Vent Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Transmission Vent Hose & Retainers
    GM1302098Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • Ensure the vent is not plugged.
    • Route the vent hose the same way as removed.
    • Ensure the vent hose is free of kinks and is routed clear of sharp objects.
  1. Connect the transmission vent hose (3) to the transmission vent tube (4).
  2. Connect the transmission vent hose retainer (1, 6) to the following:
    • The heater pipe bracket (2)
    • The transmission range selector cable bracket (5)
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals