LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Transmission Mount
    GM1201366Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission mount to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the bolts.

    Tighten:  Tighten the bolts to 60 N.m (44 lb ft).

    3. Fig 2: View Of Transmission Support
    GM1235550Courtesy of GENERAL MOTORS CORP.
  3. Lower the transmission and install the 2 nuts securing the transmission mount to the transmission support.

    Tighten:  Tighten the nuts to 57 N.m (42 lb ft).

  4. Remove the transmission jack.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals