LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Fluid Cooler Hose/Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the transmission fluid cooler lines from the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Replacement .
  3. Remove the transmission fluid cooler lines from the retainer located on the radiator.
    4. Fig 1: View Of Transmission Fluid Cooler Lines
    GM1207762Courtesy of GENERAL MOTORS CORP.
  4. Remove the transmission fluid cooler lines from the retainer located on the right side of the engine.
  5. Support the transmission with a transmission jack.
  6. Remove the transmission support. Refer to Crossmember Replacement - Transmission (2WD) .
  7. Remove the front exhaust pipe assembly. Refer to Catalytic Converter Replacement (2WD) or Catalytic Converter Replacement (4WD) .
  8. Carefully lower the transmission to gain access to the transmission fluid cooler line fittings.
  9. Disconnect the transmission fluid cooler lines from the transmission. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Replacement .
  10. Remove the transmission fluid cooler lines from the vehicle.
scientia non olet · About LEMON Manuals