LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Park/Neutral Backup Switch Adjustment

Park/Neutral Backup Switch Adjustment

WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
  • The following procedure is for vehicles that have not had the switch removed or replaced. If the switch has been removed or replaced, refer to Park/Neutral Backup Switch Replacement  for the proper adjustment procedure.
  • Apply the parking brake.
  • The engine must start in the P (PARK) or N (NEUTRAL) positions only.
  • Check the switch for proper operation. If adjustment is required, proceed as follows:
  1. Place the transmission range selector in the N (NEUTRAL) position.
  2. With an assistant in the drivers seat, raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Loosen the park/neutral position switch mounting bolts.
  4. With the vehicle in the N (NEUTRAL) position, rotate the switch while the assistant attempts to start the engine.
  5. Following a successful start, turn the engine OFF.
    6. NOTE: Refer to Fastener Notice .
  6. Tighten the bolts securing the park/neutral back up switch to the transmission.

    Tighten:  Tighten the park/neutral back up switch bolts to 27 N.m (20 lb ft).

  7. Lower the vehicle.
  8. Check the switch for proper operation. The engine must start in the P (PARK) or N (NEUTRAL) positions only.
  9. Replace the park/neutral position switch if proper operation can not be achieved. Refer to Park/Neutral Backup Switch Replacement .
scientia non olet · About LEMON Manuals