LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Filler Tube and Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Filler Tube
    GM1302099Courtesy of GENERAL MOTORS CORP.
  1. Remove the filler tube indicator.
  2. Remove the nut (3) securing the filler tube to the secondary AIR stud (2).
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Clean away all dirt and debris from the transmission filler tube area.
  5. Position an appropriate container under the transmission.
  6. Remove the filler tube (1) and seal (2) from the transmission.

    Allow the transmission fluid to drain into the container.

scientia non olet · About LEMON Manuals