LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Automatic Transmission Fluid Pressure Test Hole Plug Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Pressure Test Plug
    GM1302097Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Component Fastener Tightening Notice .
  1. Install an oil pressure test plug.

    Tighten:  Tighten the oil pressure test plug to 8 N.m (71 lb in).

  2. Check the transmission fluid level, fill if necessary. Refer to Transmission Fluid Checking .
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals