LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Turbine Shaft O-Ring Installation

Turbine Shaft O-Ring Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Identifying Turbine Shaft O-Ring
GM7634Courtesy of GENERAL MOTORS CORP.

Install the O-ring (618) on the turbine shaft. O-Ring location is location dependent.

scientia non olet · About LEMON Manuals