LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Output Shaft Installation >> Tools Required

Tools Required

WARNING: This page is about a different variant/trim than selected.

J 29837-A  Output Shaft Support Fixture. See Special Tools .

    Fig 1: View Of Output Shaft
    GM588787Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: It is important to note that the input shaft may need a light tap to fully seat into position. If the input shaft is not completely engaged, the output shaft to input carrier retainer (661) will not seat.
  1. Install the output shaft (687).
    2. Fig 2: Using J 29837-A To Install Output Shaft
    GM1730029Courtesy of GENERAL MOTORS CORP.
  2. Install the J 29837-A  as shown. See Special Tools . Support the output shaft (687) with adjustable stop (1).
scientia non olet · About LEMON Manuals