LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Oil Pump Removal >> Tools Required

Tools Required

WARNING: This page is about a different variant/trim than selected.

J 45053  Universal Clamp Press

    Fig 1: Locating Pump Bolts & Seals
    GM1730033Courtesy of GENERAL MOTORS CORP.
  1. Remove all pump bolts (2) and pump bolt seal (3).
  2. Install J 45053  over stator shaft. Tighten the clamp bolts.
  3. To prevent slipping, securely fasten the J 45053  around the stator shaft by tightening the bolts (1) with a wrench.
    4. Fig 2: Locating Pump Assembly
    GM1730035Courtesy of GENERAL MOTORS CORP.
  4. Turn the T-handle of the J 45053  to pull the pump assembly (4) from the case.
  5. Lift the pump (4) out of the case.
    6. Fig 3: View Of Fluid Pump Seal & Gasket
    GM1552919Courtesy of GENERAL MOTORS CORP.
  6. Remove the fluid pump seal (5).
  7. Remove the pump cover to case gasket (6).
scientia non olet · About LEMON Manuals