Conditions for Running the DTC
WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
- DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0117, P0118, P0120, P0121, P0201, P0202, P0203, P0204, P0205, P0220, P0442, P0443, P0446, P0449, P0452, P0453, P0455, P0496, P1516, P2101, P2135, P2176 are not set.
- The ECT Sensor parameter is more than 70°C (158°F).
- The Engine Speed parameter is between 1,500-3,500 RPM.
- The Ignition 1 Signal parameter is between 11-18 volts.
- The Engine Run Time parameter is more than 200 seconds.
- The Loop Status parameter is closed.
- The TP Indicated Angle parameter is more than 5 percent.
- The Fuel Level Sensor parameter is more than 10 percent.
- The MAP Sensor parameter is more than 30 kPa.
- The MAF Sensor parameter is between 20-50 g/s.
- DTC P1133 runs once per drive cycle when the above conditions are met for 2 seconds.