LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Instrument Panel System Displays And Gauges) >> Diagnostic Information and Procedures >> Scan Tool Output Controls

Scan Tool Output Controls

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
IPC

Scan Tool Output Control Additional Menu Selections Description
IPC Gauge Sweep Test Special Functions The instrument panel cluster (IPC) drives all of the gages at or below minimum for a few seconds when you select ON, then drives all of the gages at or above maximum for a few seconds. The IPC Display Test will end after one cycle of the gages sweep.
Displays Test Special Functions The IPC illuminates all of the indicators and the DIC display segments for 7 seconds when you select ON. The IPC turns off the indicators and the DIC display segment after 7 seconds.
Dimming Special Functions The IPC gage backlighting are commanded ON and OFF.
Engine Control Module (ECM)

Scan Tool Output Control Additional Menu Selections Description
Special Functions Malfunction Indicator Lamp (MIL) The engine control module (ECM)/powertrain control module (PCM) commands the MIL indicator ON and OFF.
scientia non olet · About LEMON Manuals