LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Instrument Panel System Displays And Gauges) >> Diagnostic Information and Procedures >> Instrument Cluster Gages Inoperative >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: If the suspect gage is the speedometer, the drive wheels of the vehicle must be raised and the transmission must be placed in drive or first gear. Refer to Lifting and Jacking the Vehicle .
  1. Ignition ON and the scan tool installed, perform the IPC Gage Sweep Test in the IPC Output Controls. Verify that all gage dials move from minimum to the maximum value and back to the gage minimum value.
    • If the gages do not perform the IPC Gage Sweep Test, replace the IPC.
  2. Start the engine with the vehicle drive wheels raised and place the transmission in drive or first gear. Verify that the speedometer value matches the scan tool Vehicle Speed parameter in the ECM Engine Data List.
    • If the speedometer is incorrect, test or replace the IPC.
scientia non olet · About LEMON Manuals