Fasten Safety Belt Warning

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

The audio amplifier activates the fasten safety belt audible warning as requested by the instrument panel cluster (IPC). The IPC sends a GMLAN message to the audio amplifier indicating the chime frequency at a slow rate and a duration of 8 seconds. The fasten safety belt warning sounds and the fasten safety belt indicator illuminates when the following occurs:

The ignition switch transitions to ON.
The inflatable restraint sensing and diagnostic module (SDM) detects that the driver's seat belt is not buckled and the signal is low. The SDM sends a GMLAN message to the IPC indicating the seat belt status.

If the seat belt is buckled when the ignition is turned ON, the chime does not sound. If the seat belt is buckled while the chime is sounding, the chime stops. If the seat belt is unbuckled after the initial transition to ON, the chime does not sound.