LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Control System & Fuel System - 3.7L - DTC P0365 To DTC P1107) >> DTC P1106 >> Test Description

Test Description

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 3:  This step attempts to pinpoint the location of the intermittent fault.
DTC P1106

Step Action Yes No
Schematic Reference: Engine Controls Schematics
Connector End View Reference: Engine Controls Connector End Views or Powertrain Control Module Connector End Views
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Start the engine.
  2. Observe the DTC Information with a scan tool.
Are DTCs P0108 or P0651 also set?		 Go to Diagnostic Trouble Code (DTC) List - Vehicle Go to Step 3 
3 
  1. Observe the MAP sensor parameter with the scan tool.
  2. Attempt to induce the fault that set the DTC by manipulating the following items:
    • The manifold absolute pressure (MAP) sensor wiring harness
    • The MAP sensor electrical connector
    • The powertrain control module (PCM) connector and wiring harness
Refer to Testing for Intermittent Conditions and Poor Connections .Is the MAP sensor pressure affected during any part of the test?		 Go to Step 4  Go to Step 8 
4 Test the low reference circuit between the PCM and the MAP sensor for an intermittent open or for high resistance. Refer to Circuit Testing and Wiring Repairs .
Did you find and correct the condition?		 Go to Step 8  Go to Step 5 
5
IMPORTANT: Disconnecting the PCM may eliminate the short during testing.
Test the MAP sensor signal circuit between the PCM and the MAP sensor for an intermittent short to voltage. Refer to Circuit Testing and Wiring Repairs .Did you find and correct the condition?		 Go to Step 8  Go to Step 6 
6 Test for an intermittent and for a poor connection at the MAP sensor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?		 Go to Step 8  Go to Step 7 
7 Test for an intermittent and for a poor connection at the PCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you complete the action?		 Go to Step 8  -
8
  1. Clear the DTCs with a scan tool.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Did the DTC fail this ignition?		 Go to Step 2  Go to Step 9 
9 Observe the Capture Info with a scan tool.
Are there any DTCs that have not been diagnosed?		 Go to Diagnostic Trouble Code (DTC) List - Vehicle System OK
scientia non olet · About LEMON Manuals