LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Engine Control System & Fuel System - 3.7L - DTC P0133 To DTC P0355) >> DTC P0340 >> Circuit Description

Circuit Description

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

The intake camshaft position (CMP) sensor produces a 1X signal for each revolution of the intake camshaft. This signal is used for startability. If the PCM does not receive a crankshaft position (CKP) sensor signal, the engine should still start based off of the information from the CAM. The CMP is connected directly to the powertrain control module (PCM) and consists of the following circuits:

If the PCM does not receive a CAM sensor pulse, DTC P0340 will set.

scientia non olet · About LEMON Manuals