Conditions for Running the DTC
WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0117, P0118, P0120, P0121, P0125, P0128, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P0140, P0141, P0201, P0202, P0203, P0204, P0205, P0220, P0442, P0443, P0446, P0449, P0452, P0453, P0455, P0496, P1133, P1516, P2101, P2135, P2176 are not set.
Passive Test
- The engine is running.
- The Engine Run Time parameter is less than 12 minutes.
- DTC P0136 runs the passive test once per drive cycle when the above conditions are met.
Intrusive Test
- The Engine Run Time parameter is more than 12 minutes.
- The ignition 1 Signal parameter is between 11-18 volts.
- The MAF sensor parameter is between 10-100 g/s.
- The Engine Speed parameter is between 1,000-5,000 RPM.
- The Vehicle Speed parameter is between 30-130 km/h (19-81 mph).
- The Short Term FT parameter is between -20 and +20 percent.
- The passive test did not pass.
- The maximum number of intrusive attempts is less than 50.
- DTC P0136 runs the intrusive test once per drive cycle when the above conditions are met.