Special Tools

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

Illustration	Tool Number/Description
Courtesy of GENERAL MOTORS CORP.	J 3289-20 Holding Fixture
Courtesy of GENERAL MOTORS CORP.	J 8092 Universal Driver
Courtesy of GENERAL MOTORS CORP.	J 8614-01 Flange and Pulley Holding Tool
Courtesy of GENERAL MOTORS CORP.	J 22738-B Valve Spring Tester
Courtesy of GENERAL MOTORS CORP.	J 22912-01 Rear Pinion and Axle Bearing Remover
Courtesy of GENERAL MOTORS CORP.	J 23907 Slide Hammer with Bearing Adapter
Courtesy of GENERAL MOTORS CORP.	J 26941 Bushing and Bearing Remover - 3-4 inch
Courtesy of GENERAL MOTORS CORP.	J 29369-2 Bushing and Bearing Remover - 2-3 inch
Courtesy of GENERAL MOTORS CORP.	J 35582 Oil Pump Seal Installer
Courtesy of GENERAL MOTORS CORP.	J 36371 Output Shaft Bearing Installer
Courtesy of GENERAL MOTORS CORP.	J 36850 Transjel Lubricant
Courtesy of GENERAL MOTORS CORP.	J 37212 Front Output Shaft Seal Installer
Courtesy of GENERAL MOTORS CORP.	J 45278 Seal Remover
Courtesy of GENERAL MOTORS CORP.	J 45759 Assembly Fixture
Courtesy of GENERAL MOTORS CORP.	J 45933 Isuzu Transfer Case Assembly/Disassembly Kit
Courtesy of GENERAL MOTORS CORP.	J 45934 Input Seal Installer
Courtesy of GENERAL MOTORS CORP.	J 45936 Control Actuator Shaft Bushing Installer
Courtesy of GENERAL MOTORS CORP.	J 45937 Rear Output Shaft Retaining Ring Installer
Courtesy of GENERAL MOTORS CORP.	J 46199 Front Output Shaft Bearing Remover and Installer