LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Transfer Case - ISUZU T150) >> Repair Instructions >> Transfer Case Neutral Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transfer Case NEUTRAL Switch & Components
    GM1313612Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Component Fastener Tightening Notice .
  1. Install the transfer case NEUTRAL switch (1) and gasket (4) into the transfer case.

    Tighten:  Tighten the neutral switch to 39 N.m (29 lb ft).

  2. Connect the brown NEUTRAL switch electrical connector (2) to the bracket (3).
    3. Fig 2: View Of Transfer Case Electrical Connectors
    GM1313610Courtesy of GENERAL MOTORS CORP.
  3. Connect the brown engine wiring harness electrical connector (1) to the brown NEUTRAL switch electrical connector (6).
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals