LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Transfer Case - ISUZU T150) >> Repair Instructions >> Transfer Case Fluid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Clean away all dirt and debris from the transfer case fluid fill and drain plug areas.
  3. Position an appropriate container under the transfer case assembly.
    4. Fig 1: View Of Transfer Case Fluid Fill And Drain Plugs
    GM1313602Courtesy of GENERAL MOTORS CORP.
  4. Remove the transfer case fluid fill plug (1) and O-ring gasket.
  5. Remove the transfer case fluid drain plug (2) and O-ring gasket.

    Allow the transfer case fluid to drain into the container.

  6. Inspect the O-ring gaskets for wear.

    Replace if necessary.

scientia non olet · About LEMON Manuals