LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Engine Mechanical - 3.7L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Valve Rocker Arm and Valve Lash Adjuster Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the valve rocker arm and fill the valve lash adjuster with oil.
  2. Install the valve rocker arm and valve lash adjuster.
  3. When the valve rocker arm and valve lash adjuster are in place, slowly rotate the engine counterclockwise enough that the cam lobe fully depresses the spring again.
    4. Fig 1: Removing EN-47945
    GM1788074Courtesy of GENERAL MOTORS CORP.
  4. Remove the EN-47945  from the cylinder head and repeat as required.
  5. Install the camshaft cover. Refer to Camshaft Cover Replacement .
scientia non olet · About LEMON Manuals