LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Engine Mechanical - 3.7L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Timing Chain Guide Replacement - Lower >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Timing Chain Guide & Bolts
    GM637585Courtesy of GENERAL MOTORS CORP.
  1. Position the lower timing chain guide to the engine.
    2. NOTE: Refer to Fastener Notice .
  2. Install the lower timing chain guide bolts.

    Tighten:  Tighten the bolts to 18 N.m (13 lb ft).

    3. Fig 2: View Of Cylinder Head Access Hole Plugs
    GM637770Courtesy of GENERAL MOTORS CORP.
  3. Install the cylinder head access hole plug.

    Tighten:  Tighten the plug to 5 N.m (44 lb in).

  4. Install the crankshaft sprocket to the crankshaft sprocket snout.

    Aligning the marked link on the timing chain with the timing mark on the crankshaft sprocket.

  5. Install the timing chain tensioner shoe. Refer to Timing Chain Tensioner Shoe Replacement .
scientia non olet · About LEMON Manuals