LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Engine Mechanical - 3.7L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exploded View Of Oil Pump
    GM659575Courtesy of GENERAL MOTORS CORP.
  1. Install the oil pump pressure relief valve and the spring.
    2. NOTE: Refer to Component Fastener Tightening Notice .
  2. Install the oil pump pressure relief valve plug.

    Tighten:  Tighten the plug to 14 N.m (124 lb in).

  3. Install the oil pump outer and inner gears as removed.
  4. Install the oil pump cover.
    5. NOTE: Refer to Fastener Notice .
  5. Install the oil pump cover bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  6. Install the engine front cover. Refer to Engine Front Cover Replacement .
scientia non olet · About LEMON Manuals