LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Engine Mechanical - 3.7L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Mount - Right
    GM1201374Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount. You will need to articulate the mount in order to install the mount.
  2. Install the engine mount bolts.
    3. Fig 2: Locating Installation Starter Bolt - Right
    GM1273485Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. To aid in the installation of the bolts, start a bolt in position (1) first.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  4. Lower the engine.
    5. Fig 3: View Of Engine Mount-To-Frame Bracket Bolt - Right
    GM1201503Courtesy of GENERAL MOTORS CORP.
  5. Install the engine mount-to-frame bracket through bolt.

    Tighten:  Tighten the bolts to 85 N.m (63 lb ft).

  6. Remove the jack stand.
  7. Install the engine shield, if equipped. Refer to Engine Protection Shield Replacement .
  8. Install the right wheel and tire assembly. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals