LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Engine Mechanical - 3.7L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Mount-To-Frame Bracket Bolt - Left
    GM1201502Courtesy of GENERAL MOTORS CORP.
  1. Remove the left wheel and tire assembly. Refer to Tire and Wheel Removal and Installation .
  2. Remove the engine shield, if equipped. Refer to Engine Protection Shield Replacement .
  3. Remove the lower intermediate steering shaft. Refer to Lower Intermediate Steering Shaft Replacement .
  4. Support the engine using a jack stand and a block of wood.
  5. Remove the engine mount-to-frame bracket through bolt for the mount being replaced.
  6. Loosen the right side through bolt.
  7. Remove the heater pipe bracket bolt from the engine mount. Refer to Heater Hose Replacement - Outlet .
  8. Raise the engine using the jack stand; the engine will tilt to one side.
    9. Fig 2: View Of Engine Mount - Left
    GM1201372Courtesy of GENERAL MOTORS CORP.
  9. Remove the engine mount bolts.
  10. Remove the engine mount. You will need to articulate the mount in order to remove the mount.
scientia non olet · About LEMON Manuals