LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Engine Mechanical - 3.7L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Lift Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Lift Bracket
    GM954203Courtesy of GENERAL MOTORS CORP.
  1. Position the engine lift bracket to the engine.
    2. NOTE: Refer to Fastener Notice .
  2. Install the bolts securing engine lift bracket to the engine.

    Tighten: 

    1. Tighten the bolts a first pass in sequence to 5 N.m (44 lb in).
    2. Tighten the bolts a final pass in sequence to 50 N.m (37 lb ft).

    3. Fig 2: View Of Generator Mounting Bolts
    GM1313647Courtesy of GENERAL MOTORS CORP.
  3. Position the generator to the engine.
  4. Install the generator mounting bolts.

    Tighten:  Tighten the bolts in sequence to 50 N.m (37 lb ft).

    5. Fig 3: View Of Engine Lift Bracket, A/C Compressor Hose/Pipe Bracket & Bolt, & Wiring Harness Conduit
    GM1350738Courtesy of GENERAL MOTORS CORP.
  5. Engage the engine wiring harness conduit (4) to the engine lift bracket (1).
  6. Install the bolt (3) securing the A/C compressor hose/pipe bracket (2) to the engine lift bracket (1).

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  7. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals