LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Engine Mechanical - 3.7L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Drive Belt Routing & Pulleys (With A/C)
    GM1350686Courtesy of GENERAL MOTORS CORP.
  1. Route the drive belt (1) over all the pulleys, excluding the water pump pulley (2).
  2. Install the 3/8 inch breaker bar on the drive belt tensioner (7) and rotate the tensioner (7) clockwise.
  3. Route the drive belt (1) over the top of the water pump pulley (2).
  4. Slowly release the tension to the drive belt tensioner (7).
    5. IMPORTANT: Ensure the drive belt is properly aligned and seated into the grooves of the drive pulleys.
  5. Inspect for proper installation of the drive belt (1) on the pulleys.
scientia non olet · About LEMON Manuals