LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Engine Mechanical - 3.7L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Balance Shaft Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the balance shaft drive chain. Refer to Balance Shaft Drive Chain Replacement .
    2. Fig 1: View Of Balance Shafts
    GM1367352Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • Do not disassemble the balance shaft assembly. Remove and install the balance shaft as a complete assembly.
    • Rotate the balance shaft to check for free rotation. If the balance shaft does not turn free, inspect the balance shaft bearings and bearing surface for damage.
  2. Remove and discard the right balance shaft bolts.
  3. Remove the right balance shaft assembly.
scientia non olet · About LEMON Manuals