LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Engine Mechanical - 3.7L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Balance Shaft Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Balance Shafts
    GM1367352Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the balance shaft bearing journals with clean engine oil.
  2. Install the right balance shaft assembly with the counterweight down to prevent damage to the balance shaft bearings.
    3. NOTE: Refer to Fastener Notice .
  3. Install the new balance shaft bolts.

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

  4. Install the balance shaft drive chain. Refer to Balance Shaft Drive Chain Replacement .
scientia non olet · About LEMON Manuals