LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Engine Mechanical - 3.7L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Water Pump Installation >> Tool Required

Tool Required

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

J 41240  Fan Clutch Remover and Installer

    Fig 1: View Of Water Pump, Gasket & Bolts
    GM856224Courtesy of GENERAL MOTORS CORP.
  1. Install the NEW water pump gasket.
  2. Install the water pump.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the water pump bolts.

    Tighten:  Tighten the water pump bolts to 10 N.m (89 lb in).

    4. Fig 2: View Of Water Pump Pulley, Bolts & J 41240
    GM856223Courtesy of GENERAL MOTORS CORP.
  4. Install the water pump pulley.
  5. Install the water pump pulley bolts.
  6. Install J 41240  to hold pulley.
  7. Tighten the water pump pulley bolts.

    Tighten:  Tighten the water pump pulley bolts to 25 N.m (18 lb ft).

  8. Remove J 41240  .
scientia non olet · About LEMON Manuals