Engine Block Plug Installation

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Engine Block Coolant Plug

Courtesy of GENERAL MOTORS CORP.

Add sealer GM P/N 12346004 (Canadian P/N 10953480) to the plug threads.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the engine block coolant plug.
Tighten: Tighten the engine block coolant plug to 50 N.m (37 lb ft).

Fig 2: View Of Front Engine Block Oil Gallery Plug

Courtesy of GENERAL MOTORS CORP.

Add sealer GM P/N 12346004 (Canadian P/N 10953480) to the plug threads.
Install the engine block oil gallery plugs to front and left of block.
Tighten:
- Tighten the side engine block oil gallery plugs to 35 N.m (26 lb ft).
- Tighten the front (1) engine block oil gallery plug to 80 N.m (40 lb ft).

Fig 3: View Of EVAP Solenoid

Courtesy of GENERAL MOTORS CORP.

Add sealer GM P/N 12346004 (Canadian P/N 10953480) to the EVAP solenoid bolt threads.
Tighten: Tighten the EVAP solenoid bolt to 10 N.m (89 lb in).

Fig 4: View Of Knock Sensor

Courtesy of GENERAL MOTORS CORP.

Install the knock sensor.
Tighten: Tighten the knock sensor to 25 N.m (18 lb ft).

Fig 5: View Of Crankshaft Position Sensor

Courtesy of GENERAL MOTORS CORP.

Add sealer GM P/N 12346004 (Canadian P/N 10953480) to the crankshaft position sensor bolt.
Install the crankshaft position sensor and bolt.
Tighten: Tighten the crankshaft position sensor bolt to 10 N.m (89 lb in).

Fig 6: View Of Oil Pressure Switch

Courtesy of GENERAL MOTORS CORP.

Install the oil pressure switch.
Tighten: Tighten the oil pressure switch to 20 N.m (15 lb ft).