LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Engine Mechanical - 3.7L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Cylinder Head Removal >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

EN-47702  Bolt Extractor Kit

    Fig 1: View Of Cylinder Head Bolts
    GM858188Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Rap on the head of each bolt using an appropriate size punch and hammer. The vibration produced by this procedure assists in successful removal. If a bolt breaks during engine disassembly, a broken bolt extractor kit EN-47702  is available to assist in removal of the remaining bolt segment.
  1. Remove and discard the cylinder head bolts.
    2. Fig 2: View Of Cylinder Head
    GM858189Courtesy of GENERAL MOTORS CORP.
  2. Remove the cylinder head.
    3. Fig 3: View Of Cylinder Head Gasket
    GM858190Courtesy of GENERAL MOTORS CORP.
  3. Remove the cylinder head gasket.
scientia non olet · About LEMON Manuals