LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Engine Mechanical - 3.7L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Camshaft Cover Installation

Camshaft Cover Installation

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Camshaft Cover & Bolts
    GM1816280Courtesy of GENERAL MOTORS CORP.
  1. Install a new camshaft cover seal.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the camshaft cover and bolts.

    Tighten:  Tighten the camshaft cover bolts to 10 N.m (89 lb in).

    3. Fig 2: View Of Ignition Control Modules & Bolts
    GM1816279Courtesy of GENERAL MOTORS CORP.
  3. Install new ignition control module seals.
  4. Install the ignition control modules and bolts.

    Tighten:  Tighten the ignition control module bolts to 10 N.m (89 lb in).

    5. Fig 3: View Of Coolant Temperature Sensor
    GM954094Courtesy of GENERAL MOTORS CORP.
  5. Add sealer GM P/N 12346004 (Canadian P/N 10953480) to the coolant temperature sensor threads.
  6. Install the coolant temperature sensor.

    Tighten:  Tighten the coolant temperature sensor to 16 N.m (12 lb ft).

scientia non olet · About LEMON Manuals