LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Intake Manifold Seal
    GM1771750Courtesy of GENERAL MOTORS CORP.
  1. Insert a NEW seal into the intake manifold groove.
  2. Position the throttle body control module to the intake manifold.
    3. NOTE: Refer to Fastener Notice .
  3. Install the throttle body control module bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    4. Fig 2: View Of Engine Wiring Harness Electrical Connector
    GM1771749Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (1) to the throttle body control module.
    5. Fig 3: View Of EVAP Canister Purge Pipe, Throttle Body Module & EVAP Canister Purge Solenoid Valve
    GM1352026Courtesy of GENERAL MOTORS CORP.
  5. Connect the EVAP canister purge pipe (1) to the throttle control module. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Install the air cleaner resonator and outlet duct. Refer to Air Cleaner Resonator and Outlet Duct Replacement .
scientia non olet · About LEMON Manuals