LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Secondary Air Injection Pump Outlet Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Air Injection (AIR) Pump Inlet & Outlet Hoses
    GM1749357Courtesy of GENERAL MOTORS CORP.
  1. Install the AIR pump outlet hose to the vehicle.
  2. Connect the AIR pump outlet hose quick connect fitting (2) to the AIR pump. Refer to Plastic Collar Quick Connect Fitting Service .
    3. Fig 2: Locating Air Injection (AIR) Pump Outlet Hose
    GM1749355Courtesy of GENERAL MOTORS CORP.
  3. Connect the AIR pump outlet hose quick connect fitting to the AIR check valve. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  5. Close the hood.
scientia non olet · About LEMON Manuals