LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Secondary Air Injection Pump Inlet Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Air Injection (AIR) Pump Inlet Hose
    GM1749356Courtesy of GENERAL MOTORS CORP.
  1. Open the hood.
  2. Disconnect the secondary air injection (AIR) pump inlet hose quick connect fitting from the air cleaner assembly. Refer to Plastic Collar Quick Connect Fitting Service .
    3. Fig 2: Removing/Installing Air Injection (AIR) Pump Inlet & Outlet Hoses
    GM1749357Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the AIR pump inlet hose quick connect fitting (1) from the AIR pump. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Remove the AIR pump inlet hose from the vehicle.
scientia non olet · About LEMON Manuals