LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Secondary Air Injection Pump Inlet Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Air Injection (AIR) Pump Inlet & Outlet Hoses
    GM1749357Courtesy of GENERAL MOTORS CORP.
  1. Install the AIR pump inlet hose to the vehicle.
  2. Connect the AIR pump inlet hose quick connect fitting (1) to the AIR pump. Refer to Plastic Collar Quick Connect Fitting Service .
    3. Fig 2: Locating Air Injection (AIR) Pump Inlet Hose
    GM1749356Courtesy of GENERAL MOTORS CORP.
  3. Connect the AIR pump inlet hose quick connect fitting to the air cleaner assembly. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Close the hood.
scientia non olet · About LEMON Manuals