LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Knock Sensor 2 Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of KS 2 Engine Wiring Harness Connector
    GM1352023Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the KS (1) and the retaining bolt to the engine block, positioning the electrical terminals rearward.

    Tighten:  Tighten the knock sensor (KS) bolt to 25 N.m (18 lb ft).

  2. Connect the engine wiring harness electrical connector (3) to the KS (1).
  3. Install the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals