LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Heated Oxygen Sensor 2 Replacement >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

J 39194-B  Heated Oxygen Sensor Wrench

NOTE: When replacing the HO2S perform the following:
  • A code clear with a scan tool, regardless of whether or not a DTC is set
  • HO2S heater resistance learn reset with a scan tool, where available

Perform the above in order to reset the HO2S resistance learned value and avoid possible HO2S failure.
NOTE: Refer to Heated Oxygen and Oxygen Sensor Notice .
scientia non olet · About LEMON Manuals