LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Tank Module
    GM1766564Courtesy of GENERAL MOTORS CORP.
  1. Align the edges of the fuel level sensor with the slots in the module bucket.
  2. Slide the fuel level sensor into position, ensure the locking tab (1) is fully engaged.
  3. Connect the fuel level sensor electrical connector to the module cover.
  4. Install the fuel tank module. Refer to Fuel Tank Module Replacement .
scientia non olet · About LEMON Manuals