LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Hose/Pipes Replacement - Chassis >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Fuel and Evaporative Emission Pipe Caution .
CAUTION: Refer to Gasoline/Gasoline Vapors Caution .
NOTE: Refer to Fuel and Evaporative Emission Hose/Pipe Connection Cleaning Notice .
    Fig 1: Identifying Chassis Fuel Feed And Evap Line Quick Connect Fittings
    GM1766566Courtesy of GENERAL MOTORS CORP.
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Disconnect the chassis fuel feed line quick connect fitting (2) from the engine line. Refer to Plastic Collar Quick Connect Fitting Service .
    4. Fig 2: Disconnecting Fuel Feed Line Quick Connect Fitting
    GM1766200Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the chassis fuel feed line quick connect fitting from the fuel tank line. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 3: View Of Fuel Feed Line Clips
    GM1766576Courtesy of GENERAL MOTORS CORP.
  5. Disengage the fuel feed line from the clips (1).
  6. Remove the chassis fuel feed line (2) from the vehicle.
scientia non olet · About LEMON Manuals