LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Fuel Tank >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Feed And EVAP Lines
    GM1766211Courtesy of GENERAL MOTORS CORP.
  1. Connect the EVAP line (1) quick connect fittings to the module and the vent valve. Refer to Plastic Collar Quick Connect Fitting Service .
  2. Engage the EVAP line to the retaining features molded into the fuel tank.
  3. Install the EVAP line to the clip on the side of the fuel tank.
  4. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals