LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Engine >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Fuel and Evaporative Emission Pipe Caution .
CAUTION: Refer to Gasoline/Gasoline Vapors Caution .
NOTE: Refer to Fuel and Evaporative Emission Hose/Pipe Connection Cleaning Notice .
    Fig 1: View Of EVAP Canister Purge Pipe, Throttle Body Module & EVAP Canister Purge Solenoid Valve
    GM1352026Courtesy of GENERAL MOTORS CORP.
  1. Refer to Plastic Collar Quick Connect Fitting Service  in order to disconnect the evaporative emission (EVAP) hose (1) from the following:
    • The throttle body assembly (2)
    • The EVAP canister purge solenoid valve (3)
  2. Remove the EVAP hose (1) from the engine.
scientia non olet · About LEMON Manuals